End-Cap Solar Filter Mount

Customizing A Baader Solar Filter Mount for Your Telescope

Off-Axis Mounting for Reflectors and Schmidt-Cassegrain Telescopes

For your standard refractor, binocular, or Maksutov objective, you will center the filter material. The collar may be made from cardboard, cardstock, or opaque flexible plastic. The cap material should not allow any light through either the hole around the Baader Material, or the edges where it connects to the collar. You may need to run duct tape or electrical tape around the join, or make the end piece hang over the collar with flanges cut to bend over the collar and be taped down.

For your standard Newtonian Reflector or Schmidt-Cassegrain, you will mount the filter material off-axis to avoid light blockage by internal components mounted inside the telescope tube. The collar may be made from cardboard, cardstock, or opaque flexible plastic. The cap material should not allow any light through either the hole around the Baader Material, or the edges where it connects to the collar. You may need to run duct tape or electrical tape around the join, or make the end piece hang over the collar with flanges cut to bend over the collar and be taped down.

[ Home | E-Mail | Order Form ]

[ Telescopes / Kits | Accessories | Baader Solar Film ]

Page design by Draco Productions using MS Front Page.

For information about this or other pages in this set, contact Draco Productions through the following e-mail address, minus the parentheses and the word or words between the parentheses. This may seem a bit cumbersome, but DP mail has turned into a Spam Box rather than a Mail Box. This should solve the problem, and make contact much simpler since only legitimate contacts should be received.

draco(ConstellationWatch)productions@hotmail.com